Water Fuel Cell Technology
Part 1
http://www.hydrowaterpower.com/hydrogenOrder.htm
Water Cars
Hydrogen Car Kits
Hydrogen Water Fuel
by Marcia Thompson
The purpose of establishing the Hydrogen Fracturing technology which ahs been
developed is to use energy from the atom to produce a system which would lend
itself to mass production. Meyer is now in the process of integrating the
Electrical Polarization Generator (EPG) into the Hydrogen Fracturing Process.
The Electrical Polarization Generator is in essence a gas battery which produces
electric energy directly from the fuel cell gases without chemical interaction.
The significance of the voltage is that it is a potential energy source, not
consumed energy.
The most significant point is that
the influence of voltage has a phenomenal effect on the splitting of the water
molecule and does it in a controlled state. Voltage from the Electrical
Polarization Generator separates the water molecule economically by not
consuming power. It's a new technology --- bringing the water molecule from a
liquid to gas ionization state, which in turn sets up the Hydrogen Fracturing
Process of destabilization of the gas atoms to release their atomic energy. The
process consumes very little power to accomplish this task.
The Voltage Intensifier Circuit
(VIC) patent development had to be fully developed to bring on the voltage
phenomenon where very low energy is being consumed.
In conjunction with this
development, a new Electron Grid Extractor Circuit (EGEC) has been fully
developed to extend the operability of the Hydrogen Gas Gun technology, which
sets up the hydrogen fracturing process. The Voltage Intensifier Circuit patent
development and Electron Grid Extraction Circuit had to be fully developed to
bring on the voltage phenomenon where very low energy is being consumed.
What is this Hydrogen Fracturing Process? Since the Water Fuel Cell (WFC)
dissociates the water molecule by the stimulation of voltage, this voltage
technology has now been applied to the Fuel Cell gas atoms to release their
atomic energy.
Meyer discovered that not only can
the water molecule be split into its component parts, but it is also possible to
separate the atoms of gases into their component parts by the same voltage
stimulation, releasing a tremendous amount of thermal explosive energy from the
atom under a controlled state. Under this process, preliminary tests show that
energy yields from one gallon of water are predicted to equal that of 44,000 to
108,000 barrels of oil. The Hydrogen Fracturing Process is environmentally safe
since the gas atoms are split into their component parts, releasing explosive
thermal energy from the gas atom. The nucleus remains intact.
Italy, Rome,
Arlington, Texas, USA
Romania, Bucharest,
Belgium, Brussels,
Mauritania, Nouakchott,
Guyana, Georgetown,
Ghana, Accra,
Japan, Tokyo City,
Liverpool, Australia,
Mongolia, Ulan Bator
http://www.hydrowaterpower.com/hydrogenOrder.htm
Contact:
Hydro Water
Power Inc
http://www.HydroWaterPower.com
support@HydroWaterPower.com
808.281.1016
Copyright ©2006- 2006 All rights reserved |