Precautions to be taken
while installing HHO generators Part 2
http://www.hydrowaterpower.com/hydrogenOrder.htm
Hydrogen Car Kits
Water Cars
Hydrogen Water Fuel
Since, the HHO gas is released into
the air intake sensors (after formation), the wire around this area could cause
a flashback. An explosion can also occur in case the wires around the intake
sensors are hot. In order to eliminate this possibility, make sure that you
install your HHO generator when your car has not been used for the last couple
of hours. You need to place the unit between the sensor and the throttle body,
since heat is mostly absent in this area. Again, don’t assume that you know
everything and in case of a doubt, ask.
When it comes to the HHO unit, it
would be a better idea to use a fuse, so as to prevent any short circuit within
or near the unit. For different models, different wiring instructions need to be
followed due to varying designs of these engines. Also, since different engines
require distinctive HHO quantity, due to their varying power requirements, so it
would be a better idea to use a flashback arrestor mechanism on your generator.
Such a mechanism can significantly reduce the chances of any flashbacks or
explosions.
Also, before installation, make sure
that your HHO generator is not running while the vehicle is shut off. This will
prevent any unnecessary leakage or accumulation of HHO inside the car hood.
UK, London,
Georgia, Tbilisi,
Bendigo, Victoria,
Portugal, Lisbon,
Zimbabwe, Hararesssss,
Mongolia, Ulan Bator,
Belize, Belmopan,
Western Sahara, El Aaiun,
Moe, Victoria,
City of Canterbury, Australia
http://www.hydrowaterpower.com/hydrogenOrder.htm
Contact:
Hydro Water
Power Inc
http://www.HydroWaterPower.com
support@HydroWaterPower.com
808.281.1016
Copyright ©2006- 2006 All rights reserved |