Half Water Half Gas
- Water for Gas HHO in 3 Easy Steps Part 2

http://www.hydrowaterpower.com/hydrogenOrder.htm
Water Cars
Hydrogen Car Kits
Hydrogen Water Fuel
3. Half Water Half Gas – Assembly &
Install of the Water For Gas HHO Cell
Once you have the necessary parts it takes approximately one hour to assemble
your half water half gas HHO unit, even if you have never done anything like
this before. You will be quite surprised at to how quick your water for gas HHO
unit will come together, I was.
You are basically just drilling 4 holes in the lid from a pattern that you print
out , bonding some tubes in place and assembling your wire electrode coil.
Honestly, it couldn’t be easier, the instructions explain everything in fine
detail. Next you want to install your newly built water for gas HHO unit in a
safe place in the engine bay, I have mounted all of mine on the firewall.
Hooking it up takes a total of about fifteen minutes as you only have two hoses
to plug in and four wires to connect before you are able to start your car and
drive away. No tuning is needed when using water for gas as the map sensor
enhancer adjusts the computers analysis of the fuel ratio.
When you choose to run your car by using water for gas you are going to wipe at
least fifty percent off your fuel bill and that’s a fantastic thing but when you
run half water half gas you are helping save the planet we inhabit and that’s
even better.
Lichtenstein, Vaduz
France, Paris
Germany, Berlin
Angola, Luanda
Grenada, St. George's
Virginia Beach, Virginia, USA
Colombia, Bogota
Czech Republic, Prague
Wanneroo, Victoria, Australia
Congo, Democratic Republic of the Kinshasa
http://www.hydrowaterpower.com/hydrogenOrder.htm
.jpg)

Contact:
Hydro Water
Power Inc
http://www.HydroWaterPower.com
support@HydroWaterPower.com
808.281.1016
Copyright ©2006- 2006 All rights reserved |