HHO Generator – Run
Your Car on Water Part 4

http://www.hydrowaterpower.com/hydrogenOrder.htm
Water Cars
Hydrogen Car Kits
Hydrogen Water Fuel
CARB/FI CONNECTION
The diagrams also show that fittings are required to the carb/FI l. There are
ready-made kits (such as by Impco) available for making your pressure fittings
to the carburetor or fuel-injector as the case may be. You will necessarily be
sealing the built-in vents and making a 1-way air-intake.
The copper mesh comprises the inadvertent backfire' protection for the reaction
chamber. Make sure that all vapor/duct junctions are air-tight and holding full
pressure without leakage. Your new 'system' is considered successful and
properly adjusted when you get the full power range at lower temp and minimum
vapor flow without blowing the pressure safety valve.
CHT (or EGT)
Monitor your engine temp with the CHT (cylinder head temp) or EGT (exhaust gas
temp) instead of your original engine temp indicator (if any). Your existing
gauge is too slow for this application and will not warn you against overheating
until after you have burnt something. Make sure that your engine runs no hotter
than in the gasoline arrangement. VDO makes a CHT gauge with a platinum sensor
that fits under your spark plug against the cylinder head (make sure it is
really clean before you re-install your spark plug (as this is also an
electrical ground).
Ireland, Dublin,
Grafton, Australia,
Finland, Helsinki,
Miami, Florida, USA
Macedonia, Skjope,
St. Paul, Minnesota, USA
City of Maitland, Australia,
The Netherlands, Amsterdam,
Germany, Berlin,
Grenada, St. George's
http://www.hydrowaterpower.com/hydrogenOrder.htm
.jpg)

Contact:
Hydro Water
Power Inc
http://www.HydroWaterPower.com
support@HydroWaterPower.com
808.281.1016
Copyright ©2006- 2006 All rights reserved |