HHO Generator – Run
Your Car on Water Part 1

http://www.hydrowaterpower.com/hydrogenOrder.htm
Water Cars
Hydrogen Car Kits
Hydrogen Water Fuel
REACTION CHAMBER
Construct as shown in the diagram.
Use a section of 4" PVC waste pipe with a threaded screw-cap fitting on one end
and a standard end-cap at the other. Make sure to drill-and-epoxy or tap threads
thru the PVC components for all fittings. Set and control the water level in the
chamber so that it well submerses the pipe electrodes; yet leave some headroom
to build up the hydrogen/oxygen vapor pressure. Use stainless steel wires inside
the chamber (fig.s 2&5) or otherwise use a protective coating; use insulated
wires outside. Ensure that the epoxy perfects the seal, or otherwise lay down a
bead of water-proof silicone that can hold pressure.
http://fuel-efficient-vehicles.org/energy-news/?page_id=927
The screw fitting may require soft
silicone sealant, or a gasket; its purpose is to hold pressure and allow
periodic inspection of the electrodes. No leaks, no problems. Make sure you get
a symmetric 1-5mm gap between the 2 stainless steel pipes. The referenced
literature suggests that the closer to 1 or 2 mm you get, the better. You will
want to get your chamber level sensor verified before you epoxy the cap on.
Make your solder connections at the wire/electrode junctions nice, smooth, and
solid; then apply a water-proof coating, e.g. the epoxy you use for joining the
pipes to the screw cap. This epoxy must be waterproof and be capable of holding
metal to plastic under pressure. You will want to get your chamber level sensor
verified before you epoxy the cap on.
Toowoomba, Queensland,
Germany, Berlin,
Suriname, Paramaribo,
Italy, Rome,
Glendale, Arizona, USA
City of Shoalhaven, Australia,
United Arab Emirates, Abu Dhabi,
Argentina, Buenos Aires City,
Papua New Guinea, Port Moresby,
Congo, Democratic Republic of the Kinshasa
http://www.hydrowaterpower.com/hydrogenOrder.htm
.jpg)

Contact:
Hydro Water
Power Inc
http://www.HydroWaterPower.com
support@HydroWaterPower.com
808.281.1016
Copyright ©2006- 2006 All rights reserved |